####################################
# PPU manager configuration settings
####################################
#
# INFO: ppu time correlation
# 	12800 (dec)  = 1 second
# 	768000 (dec) = 1 minute


# parameters to define the CHRIS configuration
set config_id		0				;# valid_range: 0..9
set config_filename 	"/proba/local/emcs/procedures/fcp/CHRIS_camera_configuration/Surmene_M5B38L748.conf"
set SRAM_start_address	0				;# valid range: 0..65535
set RAM_bank		0				;# valid range: 0..1

# parameters to handle imaging requests
set img_id		0				;# Imaging Request ID: 0..9	
set targ_location	"Surmene"
# Approximate centre image time: --:--:--
set targ_lat		40.86				;# target lattitude
set targ_lon		40.12				;# target longitude
set targ_alt		0.25				;# target altitude (km)
set max_roll_range	25.0				;# maximum roll range allowed
set init_time		2017-07-26T11:00:00.000000	;# initial time from when the image can be taken in CUC-Format
set cam_mode		1				;# camera mode: 0=without camera 1=with camera
set targ_mode		0				;# target mode: 0=imaging 1=fixed target
set warmup_time		210				;# warm up time (s)
set img_tag			80640				;# image tag number
set start_add		0				;# start address
set nb_lines		748				;# number of ground lines
set nb_bands		38				;# number of bands
set ram_bank		0				;# 0 = selects lower half of CHRIS SRAM / 1 = upper half  (*** see note 1 below)
set ccd_conf		0				;# CCD pixel binning 0 = binning off / 1 = binning on
set read_lns		1				;# Read selected lines 0 = full line readout / 1 = half line readout

set HK1_timestamp yyyy-mm-ddT--:--:--.000000
set HK2_timestamp yyyy-mm-ddT--:--:--.000000

set number_of_pictures	5				;# Used to manually specify the number of pictures to dump
set associated_dark_request	0			;# Used to manually upload a CHRIS Dark calibration request with an identical conf file
#each line of the .lst file contains 32 hex values.